I have a complete different problem. Like in the wiki, radio quality should go to zero when transmitter is switched "off" to engage Failsafe-Action. But, i get always 100% radio quality, no matter what i try.
My receiver supports own F/S (set outputs to stick positions safed on power-on while binding as F/S-commands to output) or Hold/transmitter-F/S. In both modes, radio quality stays up w/o any changes.
Is there any other way to solve this ? I cannot disable F/S at Rx-side completely (Simprop Gigascan 5).
Could this cause trouble when flying mission and getting lost of transmittr signal and Rx is going to F/S-outputsignals ?