Here is some information for my AutoQuad M4 build. It's fitting my carbon Quadcopter frame quite well. I used two layers of square foam pads for mounting. This is the same as for my other builds. The Velcro tape to secure the battery need to go underneath the M4. I'm using an 750mAh Turnigy Nano-Tech battery. She had maiden flight last night in my living room. Some outside flying will follow soon. The GPS lock with the dipole is quite fast outside (less then 30s) after an initial sat fix. Still need to do the mag calibration. The tool for converting the declinations looks to be not in the GCS anymore? I also need to fine tune some transmitter settings (need to free up a second 3 position switch). I'm using an Walkera Devo 10 transmitter with Deviation 4.01 firmware (12 cannels, DSMX) with the build in DSM receiver. The rubber loops only hold the motor wires in place. The wires are quite long (10mm) since I have CL-0820-15 motors from an early batch without the prefitted plugs.Here is the link to my Nanocopter thread at the MultiWii Forum:
http://www.multiwii.com/forum/viewtopic ... 1ddd247b6c
The Nano Quadcopter frames can be found here:
viewtopic.php?f=30&t=4272&p=31649#p31649