M4 arming, but motors don't spin
Posted: Tue Feb 10, 2015 1:47 pm
Hi,
my M4 with BLDC Hexa is now ready for take off, or should I say almost ready for take off.
I have performed the Air frame gemoetry measurements and calculated the parameters,
I performed the Thrust measurment for my motor, prop combination and entered the A1, A2 and DEFAULT_MOT_VALUE_SCAL with 950.
Arming is working perfectly the LED is showing armed and the QGC confirms as well, but my motors wont spin.
I see in QGC that my throttle is working and correct.
What have I been missing, which hinders the spinning of the motors?
Where should I look?
my M4 with BLDC Hexa is now ready for take off, or should I say almost ready for take off.
I have performed the Air frame gemoetry measurements and calculated the parameters,
I performed the Thrust measurment for my motor, prop combination and entered the A1, A2 and DEFAULT_MOT_VALUE_SCAL with 950.
Arming is working perfectly the LED is showing armed and the QGC confirms as well, but my motors wont spin.
I see in QGC that my throttle is working and correct.
What have I been missing, which hinders the spinning of the motors?
Where should I look?