Maybe handy to know, motor mixer / connection

Info and discussion about the autonomous Micro FC, suitable for nanos, micros and mini multirotors

Maybe handy to know, motor mixer / connection

Postby Teletubbie » Thu Nov 13, 2014 5:19 pm

The motor mixers are labeled A-B-C.... in the pictures, A=M1, B=M2, C=M3,.....

If you flip the board (IMU_FLIP = 1) than still be sure that the motor connections follow the mixer layout (if you not changed the parameter file)

For a X-Quad, GPS on top (IMU_FLIP = 1), following Clock Wise seen from above;

Board number 1 > M1 (A)
Board number 4 > M2 (B)
Board number 3 > M3 (C)
Board number 2 > M4 (D)


//Frank
Teletubbie
 
Posts: 162
Joined: Wed Jun 27, 2012 4:59 am
Location: Amsterdam, The Netherlands

Return to AutoQuad M4 Micro Controller

Who is online

Users browsing this forum: No registered users and 11 guests

cron