M4CAN + rOsewhite Rachel
Posted: Wed Feb 25, 2015 7:30 pm
Hey guys,
had a hard time dealing with some ESC32V3 samples but now everything looks promising
Re-build my rOsewhite Rachel frame with a new setup:
Frame: rOsewhite Rachel (http://www.rosewhite.de/en/rachel)
ESC: ESC32V3 protoytpes, connected via CAN
Flightcontroller: M4 on M4CAN expansion board (viewtopic.php?f=40&t=3857&start=70#p30957)
Motors: T-Motor AirGear 350 set, AIR2213/920KV, will use it with the stock T9545 props (http://www.rctigermotor.com/html/2014/C ... 0/279.html)
Battery: 3S
Here are some pictures!
more to come ...
had a hard time dealing with some ESC32V3 samples but now everything looks promising
Re-build my rOsewhite Rachel frame with a new setup:
Frame: rOsewhite Rachel (http://www.rosewhite.de/en/rachel)
ESC: ESC32V3 protoytpes, connected via CAN
Flightcontroller: M4 on M4CAN expansion board (viewtopic.php?f=40&t=3857&start=70#p30957)
Motors: T-Motor AirGear 350 set, AIR2213/920KV, will use it with the stock T9545 props (http://www.rctigermotor.com/html/2014/C ... 0/279.html)
Battery: 3S
Here are some pictures!
- front view - four ports mounted on the CAN distribution. FC is a black M4r6 (not the red one shown above; this will go into the CamCruiser)
- side view, added some foam unter the RECOM, heat shrink tubing cut open to keep USB ports on the ESC32V3 accessible
more to come ...