[phpBB Debug] PHP Warning: in file [ROOT]/includes/bbcode.php on line 384: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
AutoQuad Forum • View topic - CamCruiser reloaded - M4 + Quatos
Page 9 of 9

Re: CamCruiser reloaded - M4 + Quatos

PostPosted: Fri May 29, 2015 4:39 pm
by JussiH
I reset the axle slop by loosening the set screws and giving it some slight taps with a hammer. I didnt bother replacing the bearings - we replaced those 2 motors instead. But I would assume that they could be pressed or tapped out with a hammer and an axle or other suited implement. Then pressed back in place using a vise or axle pressing tool...

Once the bearing issues and axle slop was corrected, they run and perform ok, but I wouldnt expect the bearings to last long - I already was seeing signs of bearings degrading after 3-4 hours of flight.

As a side note we ordered some replacement motors that had no slop or bearing problems out of the box, so perhaps the first 8 was just bad batch....but at 42 dollars a piece, I would have expected better overall.

Even if they are cheap,it will run up fast if you have to replace the bearings after a few hours flying. Might as well spare the work and use a Xmotor or T-motor instead.

Re: CamCruiser reloaded - M4 + Quatos

PostPosted: Mon Aug 31, 2015 5:55 am
by aBUGSworstnightmare
A new video of the CamCruiser

Re: CamCruiser reloaded - M4 + Quatos

PostPosted: Mon Sep 14, 2015 6:02 am
by aBUGSworstnightmare
Another video with slightly changed parameters for QUATOS