CamCruiser FPV folding quad - Autoquad goes FPV

[aBUGSworstnightmare]

Hi,

ESC32 + Motor test will be done this weekend (hopefully). I will use the RCTimer 13x5.5 in the beginning (http://www.rctimer.com/product_920.html) on my MN3510-15 630KV (http://flyduino.net/Multikopter-Brushle ... avigator_3). My LiPos are those http://www.hobbyking.com/hobbyking/stor ... use_.html; well, not that cheap but I will exchange them to SLS in the near future.

I've used bullet connectors on every multicopter so far without problems; so I hope not to get in trouble with this one.

Well, will need to test the ESC32 placement in real life for shure. If they are making problems in the location I will relocate them to the aft compartment. Not my preferred position, but since I need the front compartment for the BLDC gimbal board there are not that many options.
Since my motors arrived today I didn't had the chance to conduct any 'real lit testings' so far.

Rgds
Joerg
aBUGSworstnightmare

[Cookiemonsta]

Ok cool
Keep me updated as I'd love to buy everything by ultimo next week
I'd love to use AQ but if everything is too close I have to find an alternative fc
Where did you get the AQ version with second pressure sensor from btw?
Tobi

[SuperSharpShooter]

I'm planning on running mt-4006s (740kv) with APC12x4.5 props on my one once it turns up.

[aBUGSworstnightmare]

[SuperSharpShooter]

I'll be using a single 4s zippy compact 5000. Hoping to keep the weight under 2kg if possible!

Couldn't justify buying 3510s when I've got these ones sitting here that I pulled off my QAV. The QAV was just on 2kg and I got 14-15 mins of flight with these motors on 10x4.5 props. Too bad that frame was a flexy piece of garbage...

[chschmid]

Joerg
What gimbal are you going to use? Pict?

Cheers
Christof

[Cookiemonsta]

How is it working out for you?

[aBUGSworstnightmare]

[kinderkram]

[chschmid]

Hi Joerg
I can cut you the parts needed.
I have 1.2mm, 1.6mm and 2.2mm cfk stock.

Cheers
Christof