AutoQuad Forum

It's time to describe my copter.
It will be good reference for testing, tunning and my questions

Some words:

- custom frame HEX+, 74cm between motors, 15cm diameter CP, Alu profiles 12x12mm
- FC AQ 6 rev.2 (FW 6.7 r100 now)
- ESC32
- T-Motor MT2814-10 (770kV)
- props APC 12x3.8 (but I think it's to large for that, will be changed RCTimer 11x5 carbon soon)
- futaba RC
- 2x5000mAh 4S LiPo
- weight RTF - 3,3kg (with gimbal, camera, additional lipo for gimbal etc)

Pictures soon.

ok, time to rebuild ...

First .. frame.

General guidelines:
- alu 12x12 profiles
- Hex+ and Hex X on the same CP
- FC and GPS antenna protection
- ESCs under motors
- universal mounts for gimbal, battery, etc.

pic soon

cnc

wycinanie.jpg (82.99 KiB) Viewed 38070 times

2D vision

some pieces of G10

powycinane_male.jpg (189.87 KiB) Viewed 38034 times

Nice, nice, nice...

Cheers
Christof

Where do you buy and cut the G10?
Thanks for the info
Angel

My friend have cnc plotter. I don't know where he buys G10 but if you want I think he can cut some pieces for you.

Thanks bluuu, It's very kind from your side. For the moment I don't need, but for sure I'll consider your proposal.

Angel

new pics:

arm1.jpg (197.86 KiB) Viewed 37957 times

ESCs covered by "plastik 70"

arm3.jpg (238.79 KiB) Viewed 37957 times

arm2.jpg (174.13 KiB) Viewed 37957 times

arm4.jpg (183.32 KiB) Viewed 37957 times

Arms "family"

arms.jpg (251.68 KiB) Viewed 37935 times