AutoQuad Forum

Just wondering what motor numbers on the AQ people are using for he following:

- CAM STAB PITCH
- CAM STAB ROLL
- CAM CONTROL PITCH
- CAM CONTROL ROLL
- CAM CONTROL YAW

Also, does the 5v bridge need to be soldered on the AQ for the above to work?

Finally, if I'm using a PPMSUM receiver, does this impact the wiring from the AQ to the alexmos board?

Thanks in advance

James

Right, all is connected
Ok, you can do that off course, keep in mind that a diode will drop 0.3-0.7V and you need to choose one that can handle around 1-2A for small motors..
What you also can do is attaching a low cost Bluetooth adapter on the rx-tx lines, I have that and it's working great. The only reason than to have an USB connected is uploading firmware.

viewed on the web:
http://www.youtube.com/watch?v=8_fAoGj5MWg
Alain