Altitude/Pos Hold low altitude
Posted: Mon Feb 15, 2016 7:41 pm
Hi everybody,
I want to to hover with my autoquad (Mid-Quadcopter) at low altitude (50cm - 1meter, I know the ground effect but 80cm should be OK) but the copter always increase his altitude (slow).
So I played with different PID-Altitude settings but no effect. The throttle factor is OK.
Is my min_throttle to high or PWM to short/long?
I don't know what I should check
Thank you!!!
I want to to hover with my autoquad (Mid-Quadcopter) at low altitude (50cm - 1meter, I know the ground effect but 80cm should be OK) but the copter always increase his altitude (slow).
So I played with different PID-Altitude settings but no effect. The throttle factor is OK.
Is my min_throttle to high or PWM to short/long?
I don't know what I should check
Thank you!!!