Page 3 of 4
Re: Motor / Propeller Problem
Posted:
Tue Dec 15, 2015 12:38 pm
by Luxar
Thanks for info, but that's not the problem. The motor run only till 4100 rpm, the ecalc website says 5100 rpm max on my setup...
Re: Motor / Propeller Problem
Posted:
Tue Dec 15, 2015 4:07 pm
by LPR
Ralf
Try running one of your motor with a common ESC to see how fast your motor and prop combination will spin to be sure that the motor specs are correct.
Have you done the throttle calibration for the ESC32 V2?
Larry
Re: Motor / Propeller Problem
Posted:
Tue Dec 15, 2015 4:29 pm
by Luxar
I'll test later an common esc. Throttle calibration for esc32 v2 ?
Re: Motor / Propeller Problem
Posted:
Tue Dec 15, 2015 4:38 pm
by aBUGSworstnightmare
Motor / Propeller Problem
Posted:
Tue Dec 15, 2015 7:53 pm
by Luxar
I can't run the calibration from cli interface. With putty I can connect and change settings if I want. But if I run the calibration, the motor start, slows down and then stopped. I must repower the esc to connect again with putty or the ground control...
Am solder another esc to the motor, but this have a wrong timing, at half throttle the motor began to stutter...looking for one "Simonk-esc", this one should work.
All other motors (3) that am connected in the past to the esc work fine...only this one makes me mad !
Am bought this motors for longer flight times, this will work, now I can hover 12 min with the same setup (in past only 6-8 min) but no reserves of power.
I don't want to by new esc or other stuff...
Edit: am using the 2.1.0 r58 b6185 firmware for the esc...with this am using the older motors too....
Re: Motor / Propeller Problem
Posted:
Wed Dec 16, 2015 7:39 am
by aBUGSworstnightmare
Motor / Propeller Problem
Posted:
Wed Dec 16, 2015 8:22 pm
by Luxar
thanks for your help again
Here the files from the esc...not happy with the results, seems that am must using an 4S setup
Re: Motor / Propeller Problem
Posted:
Thu Dec 17, 2015 7:31 am
by aBUGSworstnightmare
Motor / Propeller Problem
Posted:
Thu Dec 17, 2015 6:52 pm
by Luxar
Hello !
I`ll try your suggestions,all works ok.
Am solder an KISS esc (from my A4-NanoHexa) to one motor....WoooHH!! No start stutters or other problems ! Runs smooth and fine from zero to full throttle ! I consider to use KISS esc`s in my setup...
Re: Motor / Propeller Problem
Posted:
Thu Dec 17, 2015 7:44 pm
by aBUGSworstnightmare