Re: Motor / Propeller Problem
Posted: Fri Dec 04, 2015 10:17 pm
I'm set the start voltage to 3 V (max ?) and the start align voltage to 2.4 V. Now it's better , but not solved. In AQ misc. settings, the Min PWM is 1220 and Motor start PWM is 1220...
AutoQuad Forum
AutoQuad :: Autonomous Multi Rotor Vehicle Controller
http://forum.autoquad.org/
Motor / Propeller Problem
Page 2 of 4
Posted: Fri Dec 04, 2015 10:17 pmRe: Motor / Propeller Problem
Posted: Sat Dec 05, 2015 8:36 amThanks
I'm set the start voltage to 3 V (max ?) and the start align voltage to 2.4 V. Now it's better , but not solved. In AQ misc. settings, the Min PWM is 1220 and Motor start PWM is 1220...
I'm set the start voltage to 3 V (max ?) and the start align voltage to 2.4 V. Now it's better , but not solved. In AQ misc. settings, the Min PWM is 1220 and Motor start PWM is 1220...
Re: Motor / Propeller Problem
Posted: Mon Dec 07, 2015 5:34 pmMotor / Propeller Problem
Posted: Mon Dec 07, 2015 8:50 pmThanks for helping
What Is your suggestion for Advance ?
I'll test your suggestions tomorrow if am back from work
What Is your suggestion for Advance ?
I'll test your suggestions tomorrow if am back from work
Re: Motor / Propeller Problem
Posted: Tue Dec 08, 2015 6:57 amMotor / Propeller Problem
Posted: Tue Dec 08, 2015 7:26 pmI found a solution for me that work, thanks for help : 
: Re: Motor / Propeller Problem
Posted: Mon Dec 14, 2015 12:33 pmOnly a Short success...
The motor reach only 4200 rpm later in run, only if the calibration current is set to 30A. According on ecalc website, the motor draws only 18A at full power on 3S...if am run the calibration with this 18/20 A, the motor runs later only till 3500 rpm...and Hoover throttle is 3000/3100 rpm...
Someone ideas....
The motor reach only 4200 rpm later in run, only if the calibration current is set to 30A. According on ecalc website, the motor draws only 18A at full power on 3S...if am run the calibration with this 18/20 A, the motor runs later only till 3500 rpm...and Hoover throttle is 3000/3100 rpm...
Someone ideas....
Re: Motor / Propeller Problem
Posted: Mon Dec 14, 2015 1:21 pmRe: Motor / Propeller Problem
Posted: Mon Dec 14, 2015 8:22 pmI test various settings of timing/switch freaq./start_voltage and so on....nothing helps...only till 4100-4200 rpm 
Am set all Parameters to default, then change some as needed and run the calibration....one result in the esc32.txt attached
Tomorrow i solder a simple BLHeli ESC to the motor for test,if it possible to run the motor higher with it.
Am set all Parameters to default, then change some as needed and run the calibration....one result in the esc32.txt attached
Tomorrow i solder a simple BLHeli ESC to the motor for test,if it possible to run the motor higher with it.
Re: Motor / Propeller Problem
Posted: Tue Dec 15, 2015 11:53 amTry and increase START_VOLTAGE and START_CURRENT
Usually when a motor fails to start, it is because the starting voltage and current is set too low.
Usually when a motor fails to start, it is because the starting voltage and current is set too low.