hi,
i have a question... is it possible that many vibration could make lost of autoquad control?
i have a small quad that fly very well with 10x45 carbon fiber propellers. after a crash i change the propellers with plastic and after that i cannot control my quad. if i pitch forward or roll nothing chang in hovering. I try to change propellers and install 8x45 carbon reinforced and then i get again my quad very stable and that react to my radio. Change back to plastic 10x45 and lost again the control. Is an issue or is normal? what kind of trick i can use to remove vibration from motors? (i already use the tape on one side of every motor and test witn vibration app for iphone).
Even the graupner 8x5 eprop are not good... when i use it my quad isn't stable and don't react to command. i can use only the 8x45 carbon reinforced prop from flyduino that work very very well, but if i want to use 10x45? what kind of prop i must buy?
my motors are t-motor MT2212-16
thanks