Page 1 of 1

Calibration: Horizontal Alignment

PostPosted: Fri Jan 29, 2016 6:38 pm
by Lost_Monkey_5
When connected to a computer the Primary Flight Display has the Roll axis is inverted. Thus when the Drone is shown leaning to the left on the display it is actually leaning to the right. Although, when the entire Drone is inverted the display shows correct orientation.

Re: Calibration: Horizontal Alignment

PostPosted: Fri Jan 29, 2016 6:56 pm
by Max
Welcome to the AQ forums. We don't use the word "drone" here. :) j/k

The HUD/PFD is showing the horizon line. Horizon tilts opposite of craft. As if you're sitting in/on the craft and looking forward. I've never seen an attitude HUD display on any kind of vehicle which works otherwise.

-Max

Re: Calibration: Horizontal Alignment

PostPosted: Fri Jan 29, 2016 7:44 pm
by Lost_Monkey_5
Max, the line is Horizon tilting with the craft and not opposite.

Re: Calibration: Horizontal Alignment

PostPosted: Fri Jan 29, 2016 8:01 pm
by Max
Then maybe the IMU Flip setting is off? It is in the Misc. Settings section. http://autoquad.org/wiki/wiki/configuri ... nd-rotate/

-Max

Re: Calibration: Horizontal Alignment

PostPosted: Wed Feb 03, 2016 7:08 pm
by Lost_Monkey_5
I have an AIMU AQ6 board so there is no option for the DEFAULT_IMU_FLIP. I re-calibrated the board and it fixed the problem.