Taranis Mode 1
Posted: Fri Jul 25, 2014 3:44 pm
Hey guys,
i have a Taranis Mode 1 remote and cant figure out how to do the tare:-D.
If i perform the stick commands for the tare the AQ enters the calibration mode, which what i asume is the onboard magnetic calibration, because the leds are flashing till i "dance" with the copter. Stick commands for saving to eeprom also works, but how do i perform the tare calibration?
I ask this because my copter has a strong drift forward and the hud is slight out of level.
I use firmware version aqv6.7.r224.b1400 and groundcontrol 1.4.03
Thanks in advance
Cheers Johannes
i have a Taranis Mode 1 remote and cant figure out how to do the tare:-D.
If i perform the stick commands for the tare the AQ enters the calibration mode, which what i asume is the onboard magnetic calibration, because the leds are flashing till i "dance" with the copter. Stick commands for saving to eeprom also works, but how do i perform the tare calibration?
I ask this because my copter has a strong drift forward and the hud is slight out of level.
I use firmware version aqv6.7.r224.b1400 and groundcontrol 1.4.03
Thanks in advance
Cheers Johannes