Hello to everybody,
I have a X8 Frame Setup and since the first flight i have the problem, that the motors are oscillating.
The Octo is able to fly and also the position hold works, not good but i can leave my fingers of the transmitter.
But there is always the "oscillating sound" from the Motors, and the copter flies not well.
Also i can command roll and pitch, but as the copter stops the movement it shakes, sometimes nearly not, sometimes
very heavy...
First i thought PID tuning is the key... but i can´t find a setting...
Right now i think about vibrations.
Do you agree with me, that in the picture below the "imu acc x" is much to high?
Also "imu acc y" shoulb be lower?
And can anyone give me an idea if this vibrations can lead to oscillating Motoroutput??
I also loaded a small log file from a short flight in my garden to dropbox(file was little bit bigger than 5MB)
Can be downloades using this link: https://www.dropbox.com/s/1cb0x8p4mgd3j0p/021-AQL.LOG
I am thankful for any help, idea or experince someone of you had made.
If any further infos are needed, please let me know
many thanks in advance
greets Marco