Glitch in rates occurring at very similar times / temps

Static, Dynamic, Log File Analysis, Troubleshooting

Glitch in rates occurring at very similar times / temps

Postby hogster » Fri Mar 07, 2014 1:45 pm

Hi all :)

I've been doing my static calibrations, but have been experiencing the same glitch around the 170.000 time mark, which equates to 22-24°C – please see the attachments.

As this is happening on every log and regardless of board position, do you think it's an inherent bug / problem with the sensors? If so, is it anything to worry about, and is it ok to carry on with my dynamic calibration (not that I'm near that point yet ...)?

Many thanks,

David :)
Attachments
static 4 rate.png
Static freeze 4 - board level
static 3 rate.png
Static freeze 3 - board diagonally pointed into ground (as per 1)
static 2 rate.png
Static freeze 2 - opposite corner of board diagonally pointed into ground
static 1 rate zoom.png
Static freeze 1 - board diagonally pointed into ground
hogster
 
Posts: 239
Joined: Tue Feb 11, 2014 8:59 am

Re: Glitch in rates occurring at very similar times / temps

Postby hogster » Fri Mar 07, 2014 5:20 pm

Another static freeze test with the board level attached ... looks more like a sensor characteristic to me rather than a glitch?

Many thanks, David :)
Attachments
static 5 rate.png
Static freeze 5 - board level
hogster
 
Posts: 239
Joined: Tue Feb 11, 2014 8:59 am


Return to Calibration

Who is online

Users browsing this forum: No registered users and 14 guests

cron