by leandrolb » Tue Nov 26, 2013 10:11 pm
Sorry but I am not doing it for fun or hobby since I read the board was designed to be used as a professional solution for AP. So I am expecting a lot from it.
Yes I did the reading from outside in my backyard and in my office in both places I get the same result.
I am using a 6S setup, I power the board with a 12v BEC, 20cm from the board. from the board, I have another bec for the gimbal mounted in the same place above the gimbal, the speeds are mounted with the motors, power cabes are all crossed. The power distribuition board is mounted 5cm below of AQ.
I believe my setup is not good to work with AQ becouse there should be a lot of magnetic interference.
This is what I get from IMU_MAG inside of my office. The waves were created when I turn the board 90 degrees front back left right.
When I turn the hexa horizontaly pointing the front to north the values goes up and when I point south the lines goes down.
- Attachments
-
- IMU_MAG south and north.PNG
-
- IMU_MAG.PNG turning right and left, front and back 90º
Leandro Barancelli - Brazil
Hexacopter - AQ - frame Tarot 810 - 15x5 carbon fiber props - motors Tarot 4114 - 6S 10000mah