MAG MAGNITUDE Readings doubt

[leandrolb]

Every time that I will perform a new dance I have to reset the board to factory settings?

I have perfomed the dance with the last calculation in it I did not reset and the result was pretty much the same with just a little changes.

Sorry Jussy I tried everything in my hand to make it works and it didn't I will give up now.

[JussiH]

No, you dont need to reset or use a particular FW, since the Calibration only uses the raw voltage data from the sensors.

[leandrolb]

I live in a big city and it is dificult to find a place without celphone towers or eletrcity cables arround. I went through a golf club to tried but I get the same result. What should I do?

[teramax]

[Trnquill]

The calibration affects "sensor data", not raw voltages. So, the voltage plots in logs should remain unchanged with or without calibration. But the MAG, ACC, etc. plots should change.

After calibration you can check for example the ACC plots from your freezing-run to see they are straight line. Raw voltage data from the sensors should still be the same it was before calibration.

[teramax]