today during my first flight, the quad suddenly flipped uncontrolably and crashed, breaking the two rear props and one of the from arms. I was qietly flying in circle in Position Hold mode to check the quad, after I had rebuild it after a crash, due to wrong handling from my side (misestimated the position), and suddenly in about 2m heigth it flipped and went down with no chance to make any rescue attempt on my side.
I have tried to review the log, but could not find any hint about what caused this strange behaviour.
I have even the feeling that some signal was received causing this, despite no such stick movement occured on my side.
I want to make sure where the cause of this strange behaviour is, before I perform the next flight after rebuild.
Perhaps someone can have a look bat the log and find any hint about what caused this.
- 011-AQL.zip
- Log of flight and crash
- (3.44 MiB) Downloaded 638 times
My setup is a Spacewalk 550 frame with:
Flyduino SimonK 25A ESCs
T-Motor 2216/11
10x45CF Props
RX GR24
TX MX-20HoTT
Telemetry Mavlink2HoTT
Thanks in advance and best regards,
Jean-Gabriel