So the whole day no answer from flyduino or viacopter what to do with the board. I was not able to reach any of the shops by phone and no answer to this post or pn.
I tried it a last time yesterday and the same thing showed up. Everything is fine but the rate log is horrible at the start. I tried to use socks filled with rice, those small packs that comes with elektronic stuff and different foam. But still the two
spikes you can see above.
The only thing I did to the AQ is soldering the pins. No GPS ore something else. I flashed the firmware with no issue and tried the static calibration. No I am stuck for about 4 days with this results .
Can someone give me a hint where to find AQ Support in this case of a bad Gyro?