Hi all,
My quadcopter runs with 30amp rctimer esc's flashed with the latest SimonK firmware.
After reading a lot of posts on the forum about the right esc calibration range I'm still not sure about the right range.
At the moment I've programmed my esc's from 975 to 1950. Is this the right range?
Recently I read a post suggesting a range from 1125 to 1950.
The offical docs are very limited on this subject.
What is the correct range for the standard settings?
What effect has a range of 975 to 1950 on flying behaviour?
Best regards,
Jan Willem
The Netherlands