My board sensors are broken?

Static, Dynamic, Log File Analysis, Troubleshooting

My board sensors are broken?

Postby codeforge » Fri May 03, 2013 4:13 pm

Hi,
after many crash (4 and not so bad) i redo the static calibration but i get very large lines in rate xyz ... The acc and mag are fine but the rate are very bad i think. Could you say me if my log are good to fly again or i must change the board or the sensors (if it's possible).

Thanks
Attachments
static_rate.png
static rates
codeforge
 
Posts: 104
Joined: Tue Jul 31, 2012 11:09 pm

Re: My board sensors are broken?

Postby bn999 » Fri May 03, 2013 5:36 pm

Very large because of the vertical scale. This looks fine.
bn999
 
Posts: 1559
Joined: Thu Jun 21, 2012 11:40 pm

Re: My board sensors are broken?

Postby codeforge » Fri May 03, 2013 6:57 pm

thanks for reply,

so i can use it for calibration? or are there spike and noise?
codeforge
 
Posts: 104
Joined: Tue Jul 31, 2012 11:09 pm

Re: My board sensors are broken?

Postby JussiH » Sat May 04, 2013 5:39 pm

Should be absolutely fine for calibration
JussiH
 
Posts: 2103
Joined: Thu Jun 21, 2012 9:25 pm


Return to Calibration

Who is online

Users browsing this forum: No registered users and 11 guests