Need help on static calibration.

[auhouhz]

Hi all, need some help with static calibration.
Please see attached picture.
What could have gone wrong for ADC temp (2 lines look normal but 1 line shows -250??) and IMU rate (why is the graph showing steps)? I had follow exactly what is shown in the youtube. Could it be hardware issue?

[bn999]

Repeat the test. If the rates have the same stepped look as the ones above, the X/Y gyro chip is bad.

[auhouhz]

[bn999]

Talk to your vendor about warranty. The only temperature that is used is temp0.

[auhouhz]

Hi bn999, now that I had run another test, the rest of the curves looks good except for the rate. But this round it didnt show any steps. Do I have anything to worry about? Kindly advise. Thank you!

[bn999]

You only have to worry if those steps reoccur.