First Static Calibration Test

Static, Dynamic, Log File Analysis, Troubleshooting

First Static Calibration Test

Postby Panama TJ » Mon Mar 11, 2013 2:37 am

This was the result of my first run ever. Not sure if they're OK. I appreciate the feedback

Image

Image

Image

Image

Mark.
Panama TJ
 
Posts: 25
Joined: Sun Feb 24, 2013 3:59 pm

Re: First Static Calibration Test

Postby chschmid » Mon Mar 11, 2013 11:06 am

Hi Mark

Looks good. Maybe you try again to get rid of the ACC "bulbs". Sometimes the foam expands and moves the board a little.

Best

Christof
chschmid
 
Posts: 1800
Joined: Wed Jul 11, 2012 7:41 pm
Location: Herrliberg, Switzerland

Re: First Static Calibration Test

Postby Panama TJ » Wed Mar 20, 2013 6:24 am

Will carbon fiber disturb the static calibration? Thanks!

Mark.

Image
Panama TJ
 
Posts: 25
Joined: Sun Feb 24, 2013 3:59 pm

Re: First Static Calibration Test

Postby chschmid » Wed Mar 20, 2013 6:45 am

CFK does not disturb the calibration. But your construction may move during heat up. I would keep the container as simple as possible and make sure it can not move. I usually place mine on a thin sheet of foam. It holds the conatiner in place and absorbs "very small" vibes. The cables will get a little bit longer when defrosting and obviously push a little on the board.

Best
Christof
chschmid
 
Posts: 1800
Joined: Wed Jul 11, 2012 7:41 pm
Location: Herrliberg, Switzerland


Return to Calibration

Who is online

Users browsing this forum: No registered users and 10 guests

cron