acceptable hud level

Static, Dynamic, Log File Analysis, Troubleshooting

acceptable hud level

Postby monkey1 » Sun Mar 10, 2013 3:00 am

i had tried serveral times of recal. using different static & dyn data and get the same result hud not level (see the attached) except the hud level, everything seem ok. can i use this gen parm?
Attachments
20130310_094954.jpg
monkey1
 
Posts: 111
Joined: Tue Nov 27, 2012 2:47 am

Re: acceptable hud level

Postby LPR » Sun Mar 10, 2013 3:53 am

Monkey

Hard to give advice with so little information.
I have been able to fly all three AQ copters without a parameter file. They did not fly very well but they flew.

Larry
LPR
 
Posts: 1323
Joined: Tue Jun 26, 2012 1:29 pm
Location: MN, USA

Re: acceptable hud level

Postby monkey1 » Mon Mar 11, 2013 4:52 am

HUD not level, is it a acceptable trim level? Less than 5 degree?
monkey1
 
Posts: 111
Joined: Tue Nov 27, 2012 2:47 am

Re: acceptable hud level

Postby rwijnhov » Mon Mar 11, 2013 7:25 am

Is hud is not level then your dynamic is not good. Redo your dynamic.
rwijnhov
 
Posts: 219
Joined: Mon Jul 16, 2012 3:42 pm

Re: acceptable hud level

Postby monkey1 » Mon Mar 11, 2013 8:41 am

ok, thx for advice
monkey1
 
Posts: 111
Joined: Tue Nov 27, 2012 2:47 am


Return to Calibration

Who is online

Users browsing this forum: No registered users and 9 guests

cron