What deviation is acceptable for HUD

Static, Dynamic, Log File Analysis, Troubleshooting

What deviation is acceptable for HUD

Postby HeliHenkie » Wed Jan 16, 2013 9:27 pm

Hi all,

The first test of successfull calibration is to check if the HUD is level. I've done five calibrationsnand my HUD never was level. What deviation from level is acceptable and how can I see that on my screen in QGC?

Best regards,

Jan Willem
HeliHenkie
 
Posts: 93
Joined: Wed Oct 24, 2012 5:33 pm

Re: What deviation is acceptable for HUD

Postby JussiH » Thu Jan 17, 2013 8:54 am

A couple of degrees usually poses no immediate problems and can be trimmed out on the TX.

Can you make the test described here and post a log:

http://autoquad.org/wiki/wiki/autoquad- ... on-result/

When loading the generated parameters, are you remembering to press "write to rom" after upload and resetting or powercycling the board.
JussiH
 
Posts: 2103
Joined: Thu Jun 21, 2012 9:25 pm


Return to Calibration

Who is online

Users browsing this forum: No registered users and 11 guests

cron