Strange thing is going one here.
I noticed on my second board while Step1 and Step2 that at the start of the calculation when the data is loaded i have this errors:
checksumerror in `L` packet
checksumerror in `M` packet
This is my second run on this board, it fliew fine on my Hexa but now on the new frame i have to make new calculation.
So i freezed, danced and got very good LOG´s.
Tried different MikroSD Cards, QGC Version 1.0.4 (Aq widget) and QGC Version 1.0.5.
AQ Firmware: Version v6.6 r43 (experimental)
Also danced 4 times to get a new dynamic LOG but the error stays.
I can continue cal, now i am at Step4b but would it influence the final data?
Thanks Marcus