may i know how to do the static & Dynamic calibration again after firmware flashed? Any procedure?
Thanks in adv.
fffmonkey1
Calibration after firmware flashed
5 posts
• Page 1 of 1
Calibration after firmware flashed
by monkey1 » Mon Dec 03, 2012 1:32 am
Last edited by monkey1 on Mon Dec 03, 2012 8:12 am, edited 4 times in total.
- monkey1
- Posts: 111
- Joined: Tue Nov 27, 2012 2:47 am
Re: Calibration after firmware burn
by Max » Mon Dec 03, 2012 5:41 am
Maybe I'm not understanding the question, but there is no "calibration mode." Just flash the firmware, then calibrate like normal (gather data, run calculations). But you already did that, I thought...
-Max
-Max
- Max
- Posts: 2814
- Joined: Mon Aug 13, 2012 9:45 pm
- Location: Near Ithaca, NY, USA
Re: Calibration after firmware burn
by monkey1 » Mon Dec 03, 2012 6:16 am
When I didnt flash the firmware, the calibration ready is quick flash of green LED. After I flashed the firmware, the green LED is flash slowly. My question is can I do the calibration when the green LED flash slowly after I connect the power?
Thank in adv.
Thank in adv.
- monkey1
- Posts: 111
- Joined: Tue Nov 27, 2012 2:47 am
Re: Calibration after firmware flashed
by Max » Mon Dec 03, 2012 8:29 am
The green LED should start flashing rapidly when you insert the SD card. Or if you start up the AQ with the card already inserted.
-Max
-Max
- Max
- Posts: 2814
- Joined: Mon Aug 13, 2012 9:45 pm
- Location: Near Ithaca, NY, USA
Re: Calibration after firmware flashed
by monkey1 » Mon Dec 03, 2012 9:39 am
thank you! I forgot to put the sdcard in....stupid....
- monkey1
- Posts: 111
- Joined: Tue Nov 27, 2012 2:47 am
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 30 guests