AQ with Eurgle 9X

[leopold1]

As PPM development is under way, I would like to know if in the end it will be possible to use for example the Eurgle 9X TX and RX to fly the autoquad out of the box.
If not, will it be possible with an certain adapter or or do I have to buy a new TX?

[leopold1]

Any news on using this transmiter?

[Lyagukh]

[leopold1]

Thx Igor, for the info.
Its the same as the turnigy, just reflashed with ER9X firmware.
I'll have look at the tx modules.
Even with 7 channles,i'm very happy.

[leopold1]

I have this Frsky tx module.


Will this work?

[Lyagukh]

[leopold1]

I've been looking arround for other solutions than CPPM from my ER9X.

On HK they sell the orange RX range and came across these.
A TX module for that fits the eurgle TX


And on the RX side

The rx hs two sattelite ports and 1 Sbus.

Sattelites


Could this setup work with AQ?

[Kisssys]

[leopold1]

Thx, looks promising

I`ve got a ppm decoder coming so will try that first.

[leopold1]

Well at first glance it seems that the recommended PPM encoder isen't that safe to use out of the box. A 100ohm resistor on the signal ligne should do the trick.

Looking for another TX/RX solution it also seems that the orange rx range isen't trustworthy.


Also sbus convertors with non futuba receivers give problems. (wiki)

So what other solutions are there?

Maybe this:
Using a Spektrum DM9 on an ER9X.
On the RX side using a AR7000 or 8000 receiver.

Just a noob question concerning these receivers. Is it possible to connect the RX without satelites attached directly to J7 on the AQ board? And what are the advantages, except for the smaller size, to use only the spektum satellites?