by leopold1 » Fri Jan 11, 2013 12:40 am
Well at first glance it seems that the recommended PPM encoder isen't that safe to use out of the box. A 100ohm resistor on the signal ligne should do the trick.
Looking for another TX/RX solution it also seems that the orange rx range isen't trustworthy.
Also sbus convertors with non futuba receivers give problems. (wiki)
So what other solutions are there?
Maybe this:
Using a Spektrum DM9 on an ER9X.
On the RX side using a AR7000 or 8000 receiver.
Just a noob question concerning these receivers. Is it possible to connect the RX without satelites attached directly to J7 on the AQ board? And what are the advantages, except for the smaller size, to use only the spektum satellites?