AutoQuad Forum

thanks, I will try to compile this myself...need to learn some basic arduino first

and while looking at the code...
I also found the calculation for the horizon
would it be possible to invert this easily by swapping negative and positive numbers in there?

@ Patscherpofel
It would be great, if you could post the hex file here with the new Baudrate.
Thanks!

I dont understand where to find the hex...it burns it straight to the board from arduino
but all you have to do is to change that one number in the code...really easy

Why not change telemetry speed in AQ GCS? It it strongly required to change baud rate to 115200 in minimosd firmware?

if the build in bluetooth module is set to 115200 then you have to desolder it to change it I guess

I've use bugswotsnightmware expansion board and 3dr telemetry. Baud rate set to 56000. I think, no any changes needed in this case.
I tried to use hthis firmware ttps://github.com/night-ghost/minimosd-extra with micro minimosd board. It has many improvements and fixes. But OSD does not work. See only "Not input data!" on the screen. I tried to change tx/rx wires without success. Does anyone use it?

no data can also mean wrong baudrate, try change it in the autoquad gcs

Does any OSD firmware available that supports voltage and analog RSSI monitoring?