Page 12 of 14
Re: what osd to use?
Posted:
Thu Feb 18, 2016 3:13 pm
by Kisssys
Re: what osd to use?
Posted:
Fri Feb 19, 2016 8:56 am
by Patscherpofel
thanks, I will try to compile this myself...need to learn some basic arduino first
and while looking at the code...
I also found the calculation for the horizon
would it be possible to invert this easily by swapping negative and positive numbers in there?
Re: what osd to use?
Posted:
Fri Feb 19, 2016 10:13 am
by Patscherpofel
Re: what osd to use?
Posted:
Fri Feb 19, 2016 12:34 pm
by Simson
@ Patscherpofel
It would be great, if you could post the hex file here with the new Baudrate.
Thanks!
Re: what osd to use?
Posted:
Fri Feb 26, 2016 10:25 pm
by Patscherpofel
I dont understand where to find the hex...it burns it straight to the board from arduino
but all you have to do is to change that one number in the code...really easy
Re: what osd to use?
Posted:
Mon Feb 29, 2016 10:05 pm
by brat002
Why not change telemetry speed in AQ GCS? It it strongly required to change baud rate to 115200 in minimosd firmware?
Re: what osd to use?
Posted:
Mon Feb 29, 2016 10:54 pm
by Patscherpofel
if the build in bluetooth module is set to 115200 then you have to desolder it to change it I guess
Re: what osd to use?
Posted:
Mon Feb 29, 2016 11:21 pm
by brat002
I've use bugswotsnightmware expansion board and 3dr telemetry. Baud rate set to 56000. I think, no any changes needed in this case.
I tried to use hthis firmware
ttps://github.com/night-ghost/minimosd-extra with micro minimosd board. It has many improvements and fixes. But OSD does not work. See only "Not input data!" on the screen. I tried to change tx/rx wires without success. Does anyone use it?
Re: what osd to use?
Posted:
Tue Mar 01, 2016 2:35 pm
by Patscherpofel
no data can also mean wrong baudrate, try change it in the autoquad gcs
Re: what osd to use?
Posted:
Wed Mar 02, 2016 7:21 pm
by brat002
Does any OSD firmware available that supports voltage and analog RSSI monitoring?