Page 1 of 1

PWM Tool

PostPosted: Wed Jan 28, 2015 12:41 pm
by bluuu
I'm working on simple PWM generator for simple esc calibration, pwm reading and sending (maybe PPM too).

First screens:

main.jpg
main.jpg (141.41 KiB) Viewed 5286 times


menu.jpg


calib.jpg

Re: PWM Tool

PostPosted: Thu Jan 29, 2015 9:18 am
by JussiH
Id be very interested in building one of those....

Re: PWM Tool

PostPosted: Thu Jan 29, 2015 4:51 pm
by bluuu
No problem, i'll put a few PCBs (but I not finished PCB layout yet)

PWM Tool

PostPosted: Thu Jan 29, 2015 7:40 pm
by Luxar
Is the Code "Arduino" based? I'll have one of these tiny Displays... ;)

Re: PWM Tool

PostPosted: Thu Jan 29, 2015 7:58 pm
by bluuu
yes, it is :)

Re: PWM Tool

PostPosted: Thu Feb 26, 2015 8:44 pm
by bluuu
on the table :)

pcb.jpg
pcb.jpg (129.52 KiB) Viewed 5203 times


Now I must print a case for it

Re: PWM Tool

PostPosted: Fri Feb 27, 2015 9:54 am
by aBUGSworstnightmare
Hi Adam,
maybe this 'lil gem would have saved some hours of my life when trying to calibrate the ESC32V3 protos :?
Looking forward for more details!
Rgds
Joerg

Re: PWM Tool

PostPosted: Fri Feb 27, 2015 9:24 pm
by bluuu
Done !

At this moment there is:
- PWM sending in configurable steps by up/down buttons
- PWM reading from reciver and detecting No signal
- Esc calibration option by configurable values and interval between hi and low value

- 2 "out" port
- 1 "in" (RX) port

The tool is powered by 5V from esc or reciver or additional power supply.

If anybody want it .. send me PM.

pwm_tool1.jpg
pwm_tool1.jpg (174.17 KiB) Viewed 5162 times


pwm_tool2.jpg
pwm_tool2.jpg (155.77 KiB) Viewed 5162 times


pwm_tool3.jpg

Re: PWM Tool

PostPosted: Sat Feb 28, 2015 7:27 am
by chschmid
Congrats Adam
Nice and handy tool.

Cheers
Christof