AutoQuad Forum

I'm working on simple PWM generator for simple esc calibration, pwm reading and sending (maybe PPM too).

First screens:

main.jpg (141.41 KiB) Viewed 26816 times

Id be very interested in building one of those....

No problem, i'll put a few PCBs (but I not finished PCB layout yet)

Is the Code "Arduino" based? I'll have one of these tiny Displays...

yes, it is

on the table

pcb.jpg (129.52 KiB) Viewed 26733 times

Now I must print a case for it

Hi Adam,
maybe this 'lil gem would have saved some hours of my life when trying to calibrate the ESC32V3 protos
Looking forward for more details!
Rgds
Joerg

Done !

At this moment there is:
- PWM sending in configurable steps by up/down buttons
- PWM reading from reciver and detecting No signal
- Esc calibration option by configurable values and interval between hi and low value

- 2 "out" port
- 1 "in" (RX) port

The tool is powered by 5V from esc or reciver or additional power supply.

If anybody want it .. send me PM.

pwm_tool1.jpg (174.17 KiB) Viewed 26692 times

pwm_tool2.jpg (155.77 KiB) Viewed 26692 times

Congrats Adam
Nice and handy tool.

Cheers
Christof