PWM Tool

[bluuu]

I'm working on simple PWM generator for simple esc calibration, pwm reading and sending (maybe PPM too).

First screens:

main.jpg (141.41 KiB) Viewed 26811 times

[JussiH]

Id be very interested in building one of those....

[bluuu]

No problem, i'll put a few PCBs (but I not finished PCB layout yet)

[Luxar]

Is the Code "Arduino" based? I'll have one of these tiny Displays...

[bluuu]

yes, it is

[bluuu]

on the table

pcb.jpg (129.52 KiB) Viewed 26728 times

Now I must print a case for it

[aBUGSworstnightmare]

Hi Adam,
maybe this 'lil gem would have saved some hours of my life when trying to calibrate the ESC32V3 protos
Looking forward for more details!
Rgds
Joerg

[bluuu]

Done !

At this moment there is:
- PWM sending in configurable steps by up/down buttons
- PWM reading from reciver and detecting No signal
- Esc calibration option by configurable values and interval between hi and low value

- 2 "out" port
- 1 "in" (RX) port

The tool is powered by 5V from esc or reciver or additional power supply.

If anybody want it .. send me PM.

pwm_tool1.jpg (174.17 KiB) Viewed 26687 times

pwm_tool2.jpg (155.77 KiB) Viewed 26687 times

[chschmid]

Congrats Adam
Nice and handy tool.

Cheers
Christof