Page 4 of 4

Re: FrSky X4R/X8R S.Bus w/out inverter

PostPosted: Wed Sep 09, 2015 6:45 pm
by kinderkram
Shouldn´t make a difference which FC you are using as long as you set it (and the radio) up correctly and connect the appropriate wires GND-5V-SIG similar to the AQ shown above.

Putty enough? ;)

Re: FrSky X4R/X8R S.Bus w/out inverter

PostPosted: Wed Sep 09, 2015 10:10 pm
by MiniMe
Thanks for that info kinderkram... Appreciated

Re: FrSky X4R/X8R S.Bus w/out inverter

PostPosted: Thu Sep 17, 2015 2:15 am
by Max
Here are some alternate photos showing "Larry's method" from one page back. Uses original SBus signal pin on Rx, so no extra connectors or wires this way, and keeps the 300 Ohm resistor in place on the SBus signal line. Careful when scraping off the solder mask to expose the trace, it is easy to scrape off the copper along with it.

X4R-SB-invert-mod-step1.png

X4R-SB-invert-mod-step2.png
X4R-SB-invert-mod-step2.png (1.1 MiB) Viewed 4017 times


-Max