KISS ESC calibration with Taranis Sbus.
Posted: Tue Jan 06, 2015 4:00 pm
I would like to know if there is a way to calibrate the KISS ESC's through Sbus with the X8R from taranis.
With AQ you need to have an invertor. All outgoing signals from the taranis TX are therefore also INV. For example, my THR channel starts high and is then inverted and proparly managed by the AQ.
Now I would like to calibrate my KISS ESC's with the same RX.
Is there a way through AQ itself?
If I want to calibrate directly in ch 3 (THR) from my receiver, the signal is INV. So to commence throttle calibration I should keep the stick low?
But If I use Sbus, can I use PWM at the same time?
With AQ you need to have an invertor. All outgoing signals from the taranis TX are therefore also INV. For example, my THR channel starts high and is then inverted and proparly managed by the AQ.
Now I would like to calibrate my KISS ESC's with the same RX.
Is there a way through AQ itself?
If I want to calibrate directly in ch 3 (THR) from my receiver, the signal is INV. So to commence throttle calibration I should keep the stick low?
But If I use Sbus, can I use PWM at the same time?