Failed to arm my motors via RC

[jet]

Hi, all.
Please check the photo.
I connected PPM to my RC receiver.
In the meantime, I merely connected singal and minus cables of ESC32 to AQ6.
When I powered up my AQ6 and ESC32, I failed to arm my motors after holding throttle down and yaw (rudder) right for 3 seconds.
Any suggestions?
Thanks for help.

[chschmid]

Hi Jet

When the ESC32 led is green, the esc32 is armed. Applying throttle now will start the motor.

LED signals
red flashing no valid PWM signal (<750us or > 2100us)
prop strike
over current
green ready / armed
off running mode

Cheers
Christof

[jet]

Hi, Christof.
Thanks for your reply.
However, when I moved the throttle, nothing happened.
I may calibrate my transmitter again.
Thanks.

[chschmid]

Hi Jet

Does your Th channel put out a valid signal? Would it move a servo? Maybe you can measure the signal.

Cheers
Christof

[jet]

Hi, Christof and others.
I found the problem.
I plugged PPM to M14.
Although I had confirmed that the connectors of M14 were good, the RC receiver did not work (1.jpg).
Any suggestions?
By the way, if I wanted to use spektrum AR8000 in AQ6, which port I should connect (2.jpg)? THRO?
Thanks for help.

[chschmid]

Hi Jet

Use Spectrum sat only. Then you have all standard.
Look here

Cheers
Christof