Hi all
Simple, but hopefully not a stupid question coming up!
I've got firmware version 372 on my AQ, correctly set up the radio input (all channels correctly assigned, going from -700 to +700 or 0 to 1400), my motor output channels have been correctly set and they don't conflict, I've shorted the 5V jumpers so each opto-ESC is getting a 5V feed (checked with a DVM), the ESC servo plugs are the right way round, all the ESCs are getting raw flight pack voltage on their main power rails ... but they just sit there beeping at me as if they're not getting any PWM signal
I haven't done a dynamic calibration yet, nor experimented with the TARE function, as I assumed neither of these were necessary to at least get the ESCs to arm ... maybe I'm wrong?
Any advice on points I might have missed are much appreciated!
Many thanks, David
PS. It's nice to feel I'm slowly making progress finally, I think a maiden flight is not so far away now