Hi Autoquad users,
I'm building my first Autoquad driven Quadcopter and it seems that I stumble in the beginning. I have soldered the JP3/4 and FTDI header and powered my Board. I have a Flyduino USB-UART- CP2012. I Installed QGroundControl V1.3 RC1 on my system (Win7 64 Bit) and downloaded the AQ Compiled Firmware - Version v6.6.1 stable (b1036) for board rev. 1 & 2
I successfully flashed the Autoquad Board with rev.2 (successful in this case means that the flashing process was visible in the small log window under the "Flash Firmware" button, showing writing and verifying process with now errors. At the end a messega window asks to restart the AQ board).
I connect the cable from USB-UART Autoquad pin header to the FTDI pin header of the AQ board and made a new communication link with these settings (see screen shot for all settings):
Baud: 115200
Flow Control: Active
When I connect the log window shows "connect", but thats all.
BTW: I think I have the AQ Board rev.2, but how can I be sure? I did not find any information about that on the board itself.
Any help is welcome
Dierk