I am having problem getting aq to communicate with the spektrum satellite. I have replace the sat with orange sat also no improvement and even flash difference firmware to test it but none work. Here's what i have done so far to test it...
1. Bind rx with sat.
2. plug in sat to aq
3. link aq to ground control software by FTDI pin through rx,tx, gnd ( pc: com8)
4. select firmware 6.6.1
5. jumper J4 and power up aq with red led solid
6. flash aq with the selected firmware and with until 100% and it show done.
7. press reset button on aq turn on transmitter
8. set 10 bit on radio and set mixer & output to hex x and press transmit to aq for both setting
9. now i can arm it and throttle up slowly to highest point but motor not spining and GC on pc shows the radio channels bar moving as i move. i'm sure esc and motors working fine as i did setup them for throttle range.
10. turn off both rx and tx and turn on again and now the radio not showing any signal quality and nothing works.
What is the problem and what i have done wrong? because the radio signal only work after firmware flashed but motor not responding and without turn off the aq controller and If i recycle the power, nothing else work.
Can anyone help me on this thanks.