How to start logs?

Radio, Telemetry, FTDI/USB, ESCs, Motors, etc.

How to start logs?

Postby Andrej » Fri Mar 29, 2013 8:23 pm

after one week of I decide to continue calibration procedure and found that logs not write on card.
The same cards like before but logs absent ..
I made factory reset, bent contact on card socket and reload fw but nothing help.
It possible before I wrote some parameters to board.
Is there some command to starting logs or indications that board see the card ?
Andrej
 
Posts: 79
Joined: Fri Mar 22, 2013 5:10 pm

Re: How to start logs?

Postby Max » Fri Mar 29, 2013 9:46 pm

Simply inserting the SD card, or starting up with the card inserted, should start the logging process. The green LED will blink rapidly when logging is active (vs. blink slowly when no logging). I don't think there is any way to "break" the logging by changing parameters.

Does the SD card still work in a computer? Maybe try re-formatting it and/or scanning for errors. Also try wiggling the card while it's in the AQ socket and see if the green LED starts flashing rapidly (if it does that then adding some tape to the card to make it a little thicker might help).

-Max
Max
 
Posts: 2814
Joined: Mon Aug 13, 2012 9:45 pm
Location: Near Ithaca, NY, USA

Re: How to start logs?

Postby Andrej » Fri Mar 29, 2013 10:26 pm

This is a bit strange but from six cards one only work, all other also working but not on aq board.
Andrej
 
Posts: 79
Joined: Fri Mar 22, 2013 5:10 pm


Return to Connections

Who is online

Users browsing this forum: No registered users and 19 guests

cron