Hello,
Just got new aq board.
I can load new firmware to AQ board, but cant connect to gcs.
Make all like discribed in wiki, but when I press connect in communication window ... nothing new, the same screen like befor connecting.
Leds like described in wiki - steady red, every second green, rare blue but present microflashing blue.
GCS 1.1.1
Win7 (2 computers)
Flyduino FTDI
3s lipo on power port
J4 removed
tryed all com port speeds ... 57600, 115200 ...°
If during session disconnect FTDI from AQ board connection appear, nice voice say some param and after one two seconds it again disconnect and at the top shows red text Connection lost ...