Radio, Telemetry, FTDI/USB, ESCs, Motors, etc.
by trypt » Wed Mar 13, 2013 12:17 am
I have hooked up 6 ESC32s to my AQ board. But only M8,M9 and M11 will power up the ESC32s (red LED blinking) Is there somewhere I have to enable the rest of the outputs?
I have verified that every ESC32 is working individually.
-
trypt
-
- Posts: 48
- Joined: Mon Jan 28, 2013 1:33 pm
by axelnied » Wed Mar 13, 2013 12:21 am
trypt,
Make sure the center-pins on your AQ board are connected via solder-joint?
You are powering the ESC32s via 5V?
-
axelnied
-
- Posts: 262
- Joined: Wed Jul 04, 2012 5:51 pm
- Location: San Diego, CA, USA
by trypt » Wed Mar 13, 2013 12:30 am
Ahh, didnt notice that
thanks! works now!
-
trypt
-
- Posts: 48
- Joined: Mon Jan 28, 2013 1:33 pm
Return to Connections
Who is online
Users browsing this forum: No registered users and 28 guests