Hello all,
I'm a new owner of a AQ 6
I just finish the static calibration tomorrow will start the dynamic.
By the way i already finish the wiring and when i arm , some of the motor spin up ( please see the attached video ) with throttle in idle
http://www.youtube.com/watch?v=Ey4kMhO4ebc
It is normal because i didn't done and send the calculation parameters ? or it's a radio rc calibration problem ?
Does i need to recalibrate the ESC ? with throttle MAX when powerup the ESC and then throttle down.
I'm using Graupner Hott GR16 receiver in PPM sum
Thank you.
regards.
Pascal.