Switching external relay

Radio, Telemetry, FTDI/USB, ESCs, Motors, etc.

Switching external relay

Postby leopold1 » Fri Feb 08, 2013 9:20 pm

Is there a way to control an external relay through one of the ports and using for example ch5?
leopold1
 
Posts: 311
Joined: Tue Jul 31, 2012 11:43 pm
Location: Belgium

Re: Switching external relay

Postby Max » Fri Feb 08, 2013 10:11 pm

Not currently, though Menno does have some code written to allow for a pass-through port (RC Rx to an output port on the AQ). I've seen it but haven't tested, and I don't think it's synched up with r75, but if it would be helpful, perhaps we could post the changes somewhere for people to experiment with (this is up to Menno though, since I haven't even tried it out yet). There are other gimbal changes in the same patch, so it's a bit more complicated than just the pass-through part. The pass-through is definitely a needed/requested AQ feature.

-Max
Max
 
Posts: 2814
Joined: Mon Aug 13, 2012 9:45 pm
Location: Near Ithaca, NY, USA


Return to Connections

Who is online

Users browsing this forum: No registered users and 15 guests