Problem connecting APC220 telemetry to AQ6???????

Radio, Telemetry, FTDI/USB, ESCs, Motors, etc.

Problem connecting APC220 telemetry to AQ6???????

Postby noppita » Wed Feb 06, 2013 11:44 am

I have AQ6 ready up to static calibration and going to do dynamic calibration soon, but first i have to make sure i can get my telemetry working first. I am able to use usb FTDI board connected with AQ6 but not able to connect to my APC220.

APC220: cheap mid range telemetry solution

http://autoquad.org/wiki/wiki/autoquad- ... etry-xbee/


any one have photo showing how to connect this AC220 with AQ6 and maybe some photo showing during software configuration.
noppita
 
Posts: 52
Joined: Mon Nov 19, 2012 3:42 pm

Re: Problem connecting APC220 telemetry to AQ6???????

Postby LPR » Tue Feb 12, 2013 3:06 pm

Noppita

Very few have used the APC220 radios. You can now buy 3D radios for less than $40 at RC Timer. I'm using them and many others are also. With the 3D radios you can get all the data from the AQ.

Larry
LPR
 
Posts: 1323
Joined: Tue Jun 26, 2012 1:29 pm
Location: MN, USA

Re: Problem connecting APC220 telemetry to AQ6???????

Postby sandmen » Wed Feb 13, 2013 9:34 am

For the APC220, you need to change the baudrate on the aq.
I think 57600.
And you have to change the frequenzy in aq_mavlink.h for downloading parameter.
57600 is to slow for the "high-speed" parameter download.
sandmen
 
Posts: 997
Joined: Fri Jun 22, 2012 7:25 am

Re: Problem connecting APC220 telemetry to AQ6???????

Postby noppita » Fri Mar 01, 2013 6:32 pm

ok, i think i will try 3dr radio.

thank you every one
noppita
 
Posts: 52
Joined: Mon Nov 19, 2012 3:42 pm


Return to Connections

Who is online

Users browsing this forum: No registered users and 13 guests

cron