I'm having a lot of trouble getting the radio set up using the ground station.
I've got a Turnigy 9x running ER9x with FRSKY module, and am using the PPM output into m14, with the 27ms firmware. I have a 1.5k resistor on the signal line.
In the radio control widget, I see the bars for the channels moving as I move them, but when I assign them to the radio parameters (RADIO_ROLL_CH etc), the channels seem to swap around, or stop working properly.
For example when I move the throttle, it moves the channel 3 output to a max of 1892 us, the yaw stick changes the ch1 output from 2300us at the far left, to 2733 when centred, and no change when moved to the right. The pitch stick changes channel 2 output min 183us max 1890us, and the roll stick changes the channel 4 output min 183us, max 1890us. The percentage sliders don't really move when I make these movements.
If I understand correctly, the channel numbers in the Radio Control widget on the left, should have 1 subtracted from them before entering them into the Radio config on the right as the channels start from 0 there?
If I then reassign RADIO_ROLL_CH to 3
RADIO_RUD_CH to 1
I then get the roll stick changing the values on Channel 2, and the yaw stick changes the values in the same way on Ch1.
On my radio, the mixer is set up as follows:
CH1 RUD
CH2 ELE
CH3 THR
CH4 AIL
Help please!