by Jdmagoo » Sun Feb 16, 2014 4:42 am
Just read through the thread again, when everyone says update the Tx and Rx to the latest firmware could you please explain what version your talking about?
I just updated my Tx to FW: 1.173
and, Rx FW: v3.76
The Rx version in one of Mennos video shows v3.65, however is this because its GR16 whereas mine is GR24? Or has Graupner released a new version since then. Hard to tell as their website is very poor and doesn't display simple things like release date.
I have tested on both Arduino mini pro and Arduino micro
The RGB LPD8806 LED's work, however I can't get the autopilot Shunt current sensor to display.
I have defined the current sensor under the frame config 1 tab, however still no luck. Do i need to define elsewhere?
Also, V0.981 has the same lat/long bug as v0.93 which was fixed in v0.94
EDIT: I just connected up an ACS715 Current sensor and it seems to work, the only problem is its rated at 30A which is too little for my setup. I would really like to get the 90A Attopilot sensor to work. Does the code support this type of sensor or do i need to get a higher amperage version of the ACS type?